Purified Extract

  • How it's made

    This extract is prepared exclusively using registered ingredients. Throughout the extraction process, the flowers undergo thorough purification to eliminate any unnecessary substances, such as chlorophyll or wax. As a result, the final product primarily consists of cannabinoids. This formulation ensures that even a small dose can deliver the expected therapeutic effect.After taking a dose, the clinical effect becomes noticeable in as little as 30 seconds. It reaches its peak plasma THC concentration within 3-10 minutes and can last for up to 4 hours, depending on individual body characteristics and predisposition.

  • What extract contains

    The extract contains no additives or auxiliary substances such as solvents.Vaporizing the extract allows for the effective utilization of THC, meaning that the actual amount of the active substance absorbed into the bloodstream is higher than with an equivalent quantity of THC from flowers. It is considered less harmful than smoking because this form of therapy avoids inhaling harmful substances present in smoke.

  • How it works

    Through the vaporization of purified extract, the peak concentration of THC in the bloodstream is achieved within a timeframe of 3 to 10 minutes following inhalation. This is particularly ignificant when it comes to providing immediate relief from pain or muscle tension and in the treatment of insomnia, among other applications.

  • How to use it

    Initiate the therapy with a brief inhalation, approximately 2-3 seconds long, and, if necessary, wait between subsequent doses for about 3-4 minutes. High concentration is not a contraindication for medication use in any of the potential indications, but rather enables dose reduction to achieve the therapeutic effect.Thanks to its convenient and portable form, the medication can be administered practically anywhere, regardless of time or place. Vaporization produces a minimal amount of nearly odorless vapor, further facilitating on-demand THC intake for the patient.

Filling vape pen with extract

  • Step by step

    1. Remove the syringe from its pouch obtained from the pharmacy, then remove the cap located at its tip.
    2. Attach the needle to the syringe and press firmly to ensure it is securely attached.
    3. Holding the syringe with the needle pointing upward, evenly heat the extract with a warm stream of air for approximately one minute, until the consistency changes. You can verify this by pulling the plunger in the opposite direction of extraction. Also, heat the needle briefly to facilitate transferring the extract. You can use a hairdryer for this purpose, for example.
    4. Carefully position the needle's tip inside the glass cartridge and slowly transfer 0.45 ml (as indicated on the syringe's scale) of the extract while gently rotating the cartridge between your fingers.
    5. Attach the mouthpiece and securely seal it.
    6. Screw the cartridge onto the battery.
    7. Before taking your dose, take 2-3 short inhalations without inhaling to heat the battery.
    8. Inhale the optimal dose first into your mouth and then into your lungs. Repeat inhalations if necessary to achieve the desired effect while minimizing side effects.

  • Note

    In case of surface or hand contamination, clean with alcohol.

    Using a hairdryer is not mandatory but greatly facilitates the cartridge filling process. You can substitute the hairdryer with another source of warm air. Be cautious not to use excessively hot air, which could damage the syringe.

    The heating time of the extract may vary depending on the ambient temperature and syringe storage conditions. Insufficient warming of the extract may cause the needle to be pushed out of the syringe during transfer, resulting in spillage.